SIP User's Manual 562 Document #: LTRT-12804
Mediant 800 MSBG
4. From the 'SRD Index' drop-down list, select '0'. This associates the Proxy Set with the
LAN SRD, configured in ''Step 5: Configure Multiple SIP and RTP Interfaces'' on page
550. It allows
the device to classify calls by Proxy Set for this SRD.
Figure 8-76: Defining Device as Proxy Set
5. Click Submit.
6. Save the settings to flash memory ("burn") and reset the device (see ''Saving
Configuration'' on page 336).
8.4.10.3.3 Step 3: Define IP Group for PSTN
The procedure below describes how to configure an IP Group (#3) for PSTN users. This IP
Group represents the device's LAN SRD interface.
¾ To configure an IP Group for PSTN users:
1. Open the 'IP Group Table' page (Configuration tab > VoIP menu > Control Network
submenu > IP Group Table).
2. From the 'Index' drop-down list, select '3'.
3. From the 'Type' drop-down list, select 'SERVER'.
4. In the 'Description' field, enter a brief description of this IP Group (e.g., "PSTN Users").
5. From the 'Proxy Set ID' drop-down list, select '2' to assign it to Proxy Set #2 defined in
''Step 2: Define Device as a Proxy Set'' on page 561. Th
erefore, this IP Group is
defined with IP address 10.8.6.86 and all SIP dialog messages sent to this IP Group
are sent to this IP address (i.e., the device's LAN interface).
6. In the 'SRD' field, enter "0" to associate it with the LAN SRD (defined in ''Step 5:
Configure Multiple SIP and RTP Interfaces'' on page 550).
To Next Page
Loading...
