SIP User's Manual 408 Document #: LTRT-12804
Mediant 800 MSBG
8.1.2 Multiple SIP Signaling and Media Configuration Example
This section provides an example for configuring multiple SIP signaling and RTP
interfaces. In this example, the device serves as the interface between the enterprise's
PBX (connected using an E1/T1 trunk) and two ITSP's, as shown in the figure below:
Figure 8-4: Multiple SIP Signaling/RTP Interfaces Example
Note that only the steps specific to multiple SIP signaling/RTP configuration are described
in detail in the procedure below.
To Next Page
Loading...
