SIP User's Manual 168 Document #: LTRT-12804
Mediant 800 MSBG
¾ To configure outbound IP routing rules:
1. Open the 'Outbound IP Routing Table' page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Routing submenu > Tel to IP Routing).
Figure 3-84: Outbound IP Routing Table Page
The figure above displays the following outbound IP routing rules:
• Rule 1: If the called phone number prefix is 10 and the caller's phone number
prefix is 100, the call is assigned settings configured for IP Profile ID 1 and then
sent to IP address 10.33.45.63.
• Rule 2: For all callers (*), if the called phone number prefix is 20, the call is sent
to the destination according to IP Group 1 (which in turn is associated with a
Proxy Set ID providing the IP address).
• Rule 3: If the called phone number prefix is 5, 7, 8, or 9 and the caller belongs to
Hunt Group ID 1, the call is sent to domain.com.
• Rule 4: For all callers (*), if the called phone number prefix is 00, the call is
rejected (discarded).
• Rule 5: For all callers (*), if the called phone number prefix is 6, the call is sent to
SRD 2 (i.e., Proxy Set associated with this SRD).
• Rule 6: If an incoming IP call pertaining to Source IP Group 2 with domain.com as
source host prefix in its SIP Request-URI, the IP call is sent to IP address
10.33.45.65.
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the routing rules according to the table below.
4. Click the Submit button to apply your changes.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
To Next Page
Loading...
