SIP User's Manual 200 Document #: LTRT-12804
Mediant 800 MSBG
Table 3-33: Classification Table Parameters
Parameter Description
Matching Characteristics
Source SRD ID
[Classification_SrcSRDID]
The SRD ID (configured in the SRD table) from where the
SIP dialog request is received.
The default is -1.
Note: The source SRD is defined according to the
UDP/TCP/TLS port at which the incoming SIP dialog
request is received. The 'SIP Interface' table (SIPInterface)
defines the UDP/TCP/TLS ports per SRD (see ''Configuring
SIP Interface Table'' on page 117).
Source IP Address
[Classification_SrcAddress]
The source IP address from where the SIP dialog request is
received.
Notes:
If this parameter is not configured or is configured as an
‘*’ (asterisk), then any source IP address is accepted.
The IP address can include the "x" wildcard to represent
single digits. For example: 10.8.8.xx represents all the
addresses between 10.8.8.10 to 10.8.8.99.
The IP address can include the asterisk (*) wildcard to
represent any number between 0 and 255. For example,
10.8.8.* represents all addresses between 10.8.8.0 and
10.8.8.255.
Source Username Prefix
[Classification_SrcUsernamePrefix]
The prefix of the user part of the incoming SIP dialog
request's source URI (usually the From URI).
Note: The prefix can be a single digit or a range of digits.
For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 413.
Source Host Prefix
[Classification_SrcHost]
The From header URI host name prefix of the incoming SIP
dialog request. If this routing rule is not required, leave the
field empty. The asterisk (*) symbol can be used to depict
any source host prefix.
Destination Username Prefix
[Classification_DestUsernamePrefix]
The prefix of the incoming SIP dialog request's destination
URI (usually the Request-URI) user part.
Note: The prefix can be a single digit or a range of digits.
For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 413.
Destination Host Prefix
[Classification_DestHost]
The Request-URI host name prefix of the incoming SIP
dialog request. If this routing rule is not required, leave the
field empty. The asterisk (*) symbol can be used to depict
any destination host prefix.
Operation Rule
Source IP Group ID
[Classification_SrcIPGroupID]
The IP Group to which the incoming SIP dialog request is
assigned.
The default is -1.
Notes:
This IP Group must be one of the IP Groups associated
with the SRD.
To Next Page
Loading...
