AudioCodes Mediant 800 MSBG - Web and Telnet Parameters

SIP User's Manual 662 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: End Time
EMS: End
[DayLightSavingTimeEnd]
Defines the date and time when daylight saving ends.
The format of the value is mo:dd:hh:mm (month, day, hour, and
minutes).
Web/EMS: Offset
[DayLightSavingTimeOffset]
Daylight saving time offset (in minutes).
The valid range is 0 to 120. The default is 60.
12.2 Web and Telnet Parameters
This subsection describes the device's Web and Telnet parameters.
12.2.1 General Parameters
The general Web and Telnet parameters are described in the table below.
Table 12-9: General Web and Telnet Parameters
Parameter Description
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]
Defines up to ten IP addresses that are permitted to access the device's
Web interface and Telnet interfaces. Access from an undefined IP
address is denied. When no IP addresses are defined in this table, this
security feature is inactive (i.e., the device can be accessed from any IP
address).
The default value is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For defining the Web and Telnet Access list using the Web interface, see
''Configuring Web and Telnet Access List'' on page 77.
Web: Use RADIUS for
Web/Telnet Login
EMS: Web Use Radius
Login
[WebRADIUSLogin]
Uses RADIUS queries for Web and Telnet interface authentication.
 [0] Disable (default).
 [1] Enable.
When enabled, logging in to the device's Web and Telnet embedded
servers is performed through a RADIUS server. The device contacts a
user-defined server and verifies the given user name and password pair
against a remote database, in a secure manner.
Notes:
 The parameter EnableRADIUS must be set to 1.
 RADIUS authentication requires HTTP basic authentication, meaning
the user name and password are transmitted in clear text over the
network. Therefore, it's recommended to set the parameter
HTTPSOnly to 1 to force the use of HTTPS, since the transport is
encrypted.
 If using RADIUS authentication when logging in to the CLI, only the
primary Web User Account (which has Security Administration
access level) can access the device's CLI (see ''Configuring Web
User Accounts'' on page 73).