SIP User's Manual 98 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
bytes/sec, then this allowance would be consumed within 10
seconds, after which all traffic exceeding the allocated
40000 bytes/sec is dropped. If the actual traffic rate then
slowed to 30000 bytes/sec, then the allowance would be
replenished within 5 seconds.
Burst Bytes
[AccessList_Byte_Burst]
Tolerance of traffic rate limit (number of bytes).
Action Upon Match
[AccessList_Allow_Type]
Action upon match (i.e., 'Allow' or 'Block').
Match Count
[AccessList_MatchCount]
A read-only field displaying the number of packets
accepted/rejected by the specific rule.
3.3.2.3.2 Configuring General Security Settings
The 'General Security Settings' page is used to configure various security features. For a
description of the parameters appearing on this page, refer ''Configuration Parameters
Reference'' on page 653.
¾ To configure the general security parameters:
1. Open the 'General Security Settings' page (Configuration tab > VoIP menu >
Security submenu > General Security Settings).
Figure 3-48: General Security Settings Page
2. Configure the parameters as required.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 336.
3.3.2.4 PSTN
The PSTN submenu allows you to configure various PSTN settings and includes the
following page items:
CAS State Machines (see ''Configuring CAS State Machines'' on page 99)
Trun
k Settings (see ''Configuring Trunk Settings'' on page 101)
To Next Page
Loading...
