AudioCodes Mediant 800 MSBG - Direct Inward Dialing Parameters

SIP User's Manual 776 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
hooked for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1 ,10; (phone number "911" is
automatically dialed for Port 1 of Module 1 after being off-hooked for 10
seconds)
Notes:
 This is parameter is applicable to FXS and FXO interfaces.
 The indexing of this ini file table parameter starts at 0.
 Define this parameter for each device port that implements Automatic
Dialing.
 After a ring signal is detected on an 'Enabled' FXO port, the device
initiates a call to the destination number without seizing the line. The
line is seized only after the call is answered. After a ring signal is
detected on a 'Disabled' or 'Hotline' FXO port, the device seizes the
line.
 For configuring this table using the Web interface, see ''Configuring
Automatic Dialing'' on page 184.
 For an explanation on using ini file table parameters, see ''Configuring
ini File Table Parameters'' on page 368.
12.12.5.11 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 12-48: DID Parameters
Parameter Description
Web/EMS: Enable DID
Wink
[EnableDIDWink]
Enables Direct Inward Dialing (DID) using Wink-Start signaling.
 [0] Disable = Disables DID Wink(default).
 [1] Enable = Enables DID Wink.
If enabled, the device can be used for connection to EIA/TIA-464B DID
Loop Start lines. Both FXO (detection) and FXS (generation) are
supported. An FXO interface dials DTMF digits after a Wink signal is
detected (instead of a Dial tone). An FXS interface generates the Wink
signal after the detection of off-hook (instead of playing a Dial tone).
Note: This parameter can also be configured per Tel Profile, using the
TelProfile parameter.
Web/EMS: Delay Before
DID Wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between detection of off-hook and
generation of a DID Wink.
The valid range is 0 to 1,000. The default value is 0.
Note: This parameter is applicable only to FXS interfaces.
EMS: NTT DID Signalling
Form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices
can be connected to Japan's NTT PBX using 'Modem' DID lines. These
DID lines are used to deliver a called number to the PBX.
 [0] = FSK-based signaling (default)
 [1] = DTMF-based signaling
Note: This parameter is applicable only to FXS interfaces.