SIP User's Manual 146 Document #: LTRT-12804
Mediant 800 MSBG
3.3.2.11.1.1 Configuring Hunt Group Table
The 'Hunt Group Table' page allows you to define up to 120 Hunt Groups. This table
enables the device's channels by assigning them telephone numbers, Hunt Group IDs and
Tel Profiles. Channels that are not defined in this table are disabled. Hunt Groups are used
for routing calls (Tel-to-IP and IP-to-Tel) on the channels associated with the Hunt Group.
Note: You can also configure Hunt Groups using the ini file table parameter
TrunkGroup_x to (see ''Number Manipulation and Routing Parameters'' on
page 836).
¾ To configure the Hunt Group Table:
1. Open the 'Hunt Group Table' page (Configuration tab > VoIP menu > GW and IP to
IP submenu > Hunt Group > Hunt Group).
Figure 3-74: Hunt Group Table Page
2. Configure the Hunt Group according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to the flash memory, see ''Saving Configuration'' on page 336.
Table 3-21: Hun
t Group Table Parameters
Parameter Description
Module
[TrunkGroup_Module]
The module (i.e., FXS, FXO, PRI, or BRI) for which you want to
define the Hunt Group.
From Trunk
[TrunkGroup_FirstTrunkId]
Starting physical Trunk number in the Hunt Group. The number
of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI
modules.
To Trunk
[TrunkGroup_LastTrunkId]
Ending physical Trunk number in the Hunt Group. The number
of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI
modules.
Channels
[TrunkGroup_FirstBChannel],
The device's channels/ports (analog module) or Trunk B-
channels (digital module). To enable channels, enter the
To Next Page
Loading...
