Version 6.2 229 February 2011
SIP User's Manual 3. Web-Based Management
4. Click the Click here for Advanced Settings link; the General tab page is displayed.
The General tab allows you to define an arbitrary name for the connection (in the
‘Name’ field), view various statistical information of the connection, and disable the
connection (by clicking Disable).
5. Click the Settings tab, and then from the ‘Internet Protocol’ drop-down list, select the
IP address method used for the PPP link. This can be obtained automatically from the
ISP or defined manually (by selecting ‘Use the Following IP Address’).
Figure 3-123: Settings Tab for PPP over T1
6. Click the PPP tab, and then select the supported PPP authentication and encryption
methods. (You can also change the PPP login username and password.)
Figure 3-124: PPP Tab
7. Click the T1 tab, and then define the following as instructed by your ISP:
• Framing Method
• Line Code
• Channel Groups: define the active T1 data channels. This can be Full T1 (1.e., 1-
24) or Fractional T1 (e.g., 1-3,5,8-12,24)
• Clock Master
To Next Page
Loading...
