SIP User's Manual 250 Document #: LTRT-12804
Mediant 800 MSBG
2. Add a new Access List group name:
a. Click the New ACL
link; the 'Access List Name' page appears.
Figure 3-157: Defining Access List Name
b. In the 'Access List Name' field, enter a name for the Access List rule group, and
then click OK; the Access Lists table re-appears, displaying the newly added
Access List rule group.
3. Add rules to the Access List group:
a. Under the Access List name that you defined (in Step 2), click the New Entry
link; the following page appears for defining a rule:
Figure 3-158: Adding an Access List Rules
The 'Matching' and 'Operation' groups define the operation to be executed when
matching conditions apply.
b. Configure the 'Matching' parameters to define characteristics of the packets
matching the rule:
♦ Source Address: Specify the source address (i.e., computers) of packets
sent or received by the device. Select an address or a name from the list to
apply the rule on the corresponding host, or 'Any' to apply the rule on all the
device's LAN hosts. If you want to add a new address, select the 'User
Defined' option to add a new Network Object representing the new host (see
''Configuring Network Objects'' on page 284).
♦ Destination Address: Destination address of packets sent or received by
the device. This address can be configured in the same manner as the
source address.
♦ Protocol: Specify a traffic protocol. Selecting the 'Show All Services' option
expands the list of available protocols. Select a protocol or add a new one
using the 'User Defined' option to add a new Service representing the
protocol (see ''Configuring Protocols'' on page 283).
To Next Page
Loading...
