Version 6.2 383 February 2011
SIP User's Manual 5. EMS-Based Management
2. Select the MLPP tab; the 'MLPP' screen appears.
Figure 5-11: MLPP Screen
3. Configure the MLPP parameters as required.
Note: If the following RTP DSCP parameters are set to “-1” (i.e., Not Configured,
Default), the DiffServ value is set with the
PremiumServiceClassMediaDiffserv global gateway parameter, or by using IP
Profiles: MLPPRoutineRTPDSCP, MLPPPriorityRTPDSCP,
MLPPImmediateRTPDSCP, MLPPFlashRTPDSCP,
MLPPFlashOverRTPDSCP, MLPPFlashOverOverRTPDSCP,
MLPPNormalizedServiceDomain.
5.7 Configuring the Device to Operate with SNMPv3
This section describes the SNMPv3 configuration process:
Configuring SNMPv3 using SSH
Configuring SNMPv3 using EMS (non-configured SNMPv3 System)
Configuring SNMPv3 using EMS (pre-configured SNMPv3 System)
Note: After configuring SNMPv3, ensure that you disable IPSec.
To Next Page
Loading...
