AudioCodes Mediant 800 MSBG - Table 3-34: IP2 IP Routing Table Parameters; Figure 3-107: IP2 IP Routing Table

SIP User's Manual 202 Document #: LTRT-12804
Mediant 800 MSBG
Notes:
• For a specific IP-to-IP routing rule to be effective, the incoming SIP dialog
message must match the characteristics configured for that rule.
• The 'IP2IP Routing' table can also be configured using the ini file table
parameter IP2IPRouting (see ''SBC Parameters'' on page 858).
¾ To configure SBC IP-to-IP routing rules:
1. Open the 'IP2IP Routing Table' page (Configuration tab > VoIP menu > SBC
submenu > Routing SBC submenu > IP to IP Routing Table).
Figure 3-107: IP2IP Routing Table Page
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
Table 3-34: I
P2IP Routing Table Parameters
Parameter Description
Matching Characteristics
Source IP Group ID
[IP2IPRouting_SrcIPGroupID]
The IP Group from where the IP-to-IP call originated.
Typically, the IP Group of an incoming SIP dialog is
determined (or classified) using the ‘Classification’ table (see
''Configuring Classification Table'' on page 198). If not used
(i.e., any IP G
roup), simply leave the field empty.
The default is -1.
Source Username Prefix
[IP2IPRouting_SrcUsernamePrefix]
The prefix of the user part of the incoming SIP dialog's
source URI (usually the From URI).
The default is "*".
Note: The prefix can be a single digit or a range of digits.
For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 413.
Source Host
[IP2IPRouting_SrcHost]
The host part of the incoming SIP SIP dialog's source URI
(usually the From URI). If this rule is not required, leave the
field empty. To denote any host name, use the asterisk (*)
symbol.
The default is "*".
Destination Username Prefix
[IP2IPRouting_DestUsernamePrefix]
The prefix of the incoming SIP SIP dialog's destination URI
(usually the Request URI) user part. If this rule is not
required, leave the field empty. To denote any prefix, use the
asterisk (*) symbol.
The default is "*".
Note: The prefix can be a single digit or a range of digits.