Version 6.2 203 February 2011
SIP User's Manual 3. Web-Based Management
Parameter Description
For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 413.
Destination Host
[IP2IPRouting_DestHost]
The host part of the incoming SIP SIP dialog’s destination
URI (usually the Request-URI). If this rule is not required,
leave the field empty. The asterisk (*) symbol can be used to
depict any destination host.
The default is "*".
RequestType
[IP2IPRouting_RequestType]
The SIP dialog request type of the incoming SIP dialog.
[0] All (default)
[1] INVITE
[2] REGISTER
[3] SUBSCRIBE
[4] INVITE and REGISTER
[5] INVITE and SUBSCRIBE
Operation Routing Rule (when match occurs in characteristics)
Destination Type
[IP2IPRouting_DestType]
Determines the destination type to which the outgoing SIP
dialog is sent.
[0] IP Group (default) = The SIP dialog is sent to the IP
Group’s Proxy Set (SERVER-type IP Group) or
registered contact from the database (if USER-type IP
Group).
[1] Dest Address = The SIP dialog is sent to the address
configured in the following fields: 'Destination SRD ID',
'Destination Address', 'Destination Port', and 'Destination
Transport Type'.
[2] Request URI = The SIP dialog is sent to the address
indicated in the incoming Request-URI. If the fields
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these fields take precedence.
[3] ENUM = An ENUM query is sent to include the
destination address. If the fields 'Destination Port' and
'Destination Transport Type' are configured, the incoming
Request-URI parameters are overridden and these fields
take precedence.
Destination IP Group ID
[IP2IPRouting_DestIPGroupID]
The IP Group ID to where you want to route the call. The
SIP dialog messages are sent to the IP address defined for
the Proxy Set associated with this IP Group. If you select an
IP Group, it is unnecessary to configure a destination IP
address (in the 'Destination Address' field). However, if both
parameters are configured, then the IP Group takes
precedence.
If the destination IP Group is of USER type, the device
searches for a match between the Request-URI (of the
received SIP dialog) to an AOR registration record in the
device's database. The SIP dialog is then sent to the IP
address of the registered contact.
The default is -1.
To Next Page
Loading...
