SIP User's Manual 204 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Notes:
This parameter is only relevant if the parameter
'Destination Type' is set to 'IP Group'. However,
regardless of the settings of the parameter 'Destination
Type', the IP Group is still used - only for determining the
IP Profile or outgoing SRD. If neither IP Group nor SRD
are defined in this table, the destination SRD is
determined according to the source SRD associated with
the Source IP Group (configured in the 'IP Group' table,
see ''Configuring IP Groups'' on page 119). If this
table
does not define an IP Group but only an SRD, then the
first IP Group associated with this SRD (in the 'IP Group'
table) is used.
If the selected destination IP Group ID is type SERVER,
the request is routed according to the IP Group
addresses.
If the selected destination IP Group ID is type USER, the
request is routed according to the IP Group specific
database (i.e., only to registered users of the selected
database).
If the selected destination IP Group ID is ANY USER ([-
2]), the request is routed according to the general
database (i.e., any matching registered user).
Destination SRD ID
[IP2IPRouting_DestSRDID]
The SRD ID.
The default is -1.
Note: The destination IP Group must belong to the
destination SRD, if both are configured in this table.
Destination Address
[IP2IPRouting_DestAddress]
The destination IP address (or domain name, e.g.,
domain.com) to where the call is sent.
Notes:
This parameter is applicable only if the parameter
'Destination Type' is set to 'Dest Address' [1].
When using domain names, enter a DNS server IP
address or alternatively, define these names in the
'Internal DNS Table' (see ''Configuring the Internal SRV
Table'' on page 92).
Destination Port
[IP2IPRouting_DestPort]
The destination port to where the call is sent.
Destination Transport Type
[IP2IPRouting_DestTransportType]
The transport layer type for sending the call:
[-1] Not Configured (default)
[0] UDP
[1] TCP
[2] TLS
Note: When this parameter is set to -1, the transport type is
determined by the parameter SIPTransportType.
To Next Page
Loading...
