AudioCodes Mediant 800 MSBG - Data Settings

SIP User's Manual 222 Document #: LTRT-12804
Mediant 800 MSBG
3.3.3 Data Settings
The Data menu allows you to configure the device's data routing functionality. This menu
contains the following submenus:
 WAN Access (see ''WAN Access'' on page 224)
 Fire
wall and ACL (see ''Firewall and ACL'' on page 238)
 QoS (see ''Q
oS'' on page 252)
 VPN (see ''V
PN'' on page 262)
 Data Servi
ces (see ''Data Services'' on page 270)
 Data Routing
(see ''Data Routing'' on page 276)
 Obje
cts and Rules (see ''Objects and Rules'' on page 283)
 Data System
(see ''Configuring Network Connections'' on page 287)
Before you begin
configuring the data functionality, you should familiarize yourself with
working with the data-related configuration pages, as described in ''Getting Acquainted with
Data Configuration Pages'' on page 223.
Notes:
• Virtual Routing and Forwarding (VRF) can only be configured using the
device's CLI. This allows multiple instances of a routing table to co-exist
within the same router at the same time. The device’s VRF feature allows
interfaces to be clustered into a VRF to provide segregated routing
domains. The VRF feature uses the device’s single physical router as
multiple logical routers (up to 32). Each VRF is associated with its own
routing table. When creating fully separated logical routers on the same
physical router, every interface can be mapped to a specified VRF and
static routes can be added to it. The main CLI command for configuring
VRF is ip vrf. Note: Some features are available only on the default,
unnamed, VRF. These include, amongst others, BGP, OSPF, RIP,
Management interfaces (Web, CLI and SNMP), and SIP (when using the
device’s VoIP component). For a complete list of features supported only
on the default VRF, please contact AudioCodes. For a detailed
description of CLI configuration, refer to the MSBG Series CLI Reference
Guide.
• IPSec tunneling can only be configured using the device's CLI. This is
configured using the crypto CLI commands. For a detailed description
of CLI configuration, refer to the MSBG Series CLI Reference Guide.
• Power over Ethernet (PoE) status indication when an IP Phone is
connected to one of the device’s LAN ports. This status is provided by
the CLI GetPOEPortStatusCmd command, which when run, displays the
status.
• The device supports the monitoring of traffic traversing its LAN ports (i.e.,
Port Mirroring). This includes monitoring of egress and/or ingress traffic.
This feature is useful for analyzing traffic or debugging network problems.
The CLI commands, port monitor and show data port-monitoring are
used for displaying this information.