Version 6.2 113 February 2011
SIP User's Manual 3. Web-Based Management
3.3.2.7 Applications Enabling
3.3.2.7.1 Enabling Applications
The 'Applications Enabling' page allows you to enable the following applications:
Stand-Alone Survivability (SAS) application
Session Border Control (SBC) application
Notes:
• This page displays the application only if the device is installed with the
relevant Software Upgrade Key supporting the application (see ''Loading
Software Upgrade Key'' on page 339).
• The IP2IP application will only be supported in the next applicable
release.
• For enabling an application, a device reset is required.
¾ To enable an application:
1. Open the 'Applications Enabling' page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
Figure 3-61: Applications Enabling Page
2. Save the changes to the device's flash memory and then reset the device (see
''Saving Configuration'' on page 336).
3.3.2.8 Control Network
The Control Network submenu allows you to configure various SIP call control settings.
This menu contains the following page items:
SRD Table (see Configuring SRD Table on page 114)
SIP Interface Table (se
e Configuring SIP Interface Table on page 117)
IP Group Ta
ble (see Configuring IP Groups on page 119)
Proxy Sets Table (see
Configuring Proxy Sets Table on page 126)
To Next Page
Loading...
