AudioCodes Mediant 800 MSBG - Figure 3-36: SNMP Community String Page; Table 3-8: SNMP Community String Parameters Description

Version 6.2 79 February 2011
SIP User's Manual 3. Web-Based Management
¾ To configure the SNMP community strings:
1. Open the 'SNMP Community String' page (Maintenance tab > System menu >
Management submenu > SNMP submenu > SNMP Community String).
Figure 3-36: SNMP Community String Page
2. Configure the SNMP community strings parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
To delete a community stri
ng, select the Delete check box corresponding to the community
string that you want to delete, and then click Submit.
Table 3-8: SNMP Community String Parameters Description
Parameter Description
Community String
 Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
 Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Trap Community String
[SNMPTrapCommunityString]
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.