Version 6.2 765 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
sequence in the CPT file.
SIP Alert-Info header examples:
9 Alert-Info:<Bellcore-dr2>
9 Alert-Info:<http://…/Bellcore-dr2> (where "dr2" defines
call waiting tone #2)
The SIP INFO message is according to Broadsoft's
application server definition. Below is an example of such an
INFO message:
INFO sip:06@192.168.13.2:5060 SIP/2.0
Via:SIP/2.0/UDP
192.168.13.40:5060;branch=z9hG4bK040066422630
From:
<sip:4505656002@192.168.13.40:5060>;tag=1455352915
To: <sip:06@192.168.13.2:5060>
Call-ID:0010-0008@192.168.13.2
CSeq:342168303 INFO
Content-Length:28
Content-Type:application/broadsoft
play tone CallWaitingTone1
12.12.5.3 Call Forwarding Parameters
The call forwarding parameters are described in the table below.
Table 12-40: Call Forwarding Parameters
Parameter Description
Web: Enable Call Forward
[EnableForward]
Determines whether Call Forward is enabled.
[0] Disable = Disable the Call Forward service.
[1] Enable = Enable Call Forward service (using REFER)
(default).
For FXS interfaces, the 'Call Forward' table (FwdInfo parameter)
must be defined to use the Call Forward service.
Note: To use this service, the devices at both ends must support
this option.
Web: Call Forwarding Table
EMS: SIP Endpoints > Call Forward
[FwdInfo]
This ini file table parameter forwards (redirects) IP-to-Tel calls (using
SIP 302 response) to other device ports or an IP destination, based
on the device's port to which the call was originally routed.
The format of this parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,
Type = the scenario for forwarding the call:
9 [0] Deactivate = Don't forward incoming calls (default).
To Next Page
Loading...
