SIP User's Manual 194 Document #: LTRT-12804
Mediant 800 MSBG
3.3.2.12 SBC
The SBC submenu allows you to configure the SBC application. This submenu includes
the following items:
General Settings (see ''Configuring General Settings'' on page 194)
Admission
Control (see ''Configuring Admission Control'' on page 195)
Allowed
Coders Group (see ''Configuring Allowed Coder Groups'' on page 197)
Routin
g SBC:
• Classification Table (see ''Configuring the Classification Table'' on page 198)
• IP to IP Routing Table
(see ''Configuring the IP-to-IP Routing'' on page 201)
• Alternative Routing Rea
sons (see ''Configuring Alternative Routing Reasons'' on
page 206)
Manipul
ations SBC:
• Message (see ''Configuring Message Manipulations'' on page 206)
• IP to IP Inbound (see ''
Configuring IP-to-IP Inbound Manipulations'' on page 210)
• IP to IP Outbound (se
e ''Configuring IP-to-IP Outbound Manipulations'' on page
212)
Notes: The SBC submenu appears only if you have enabled the SBC application
(see ''Enabling Applications'' on page 113) and the SBC Software Upgrade
Key is installed on the device (see ''Loading Software Upgrade Key'' on page
339).
3.3.2.12.1 Configuring General Settings
The 'General Settings' page allows you to configure general SBC parameters. For a
description of these parameters, see ''SBC Parameters'' on page 858.
¾ To configure general parameters:
1. Open the 'General Settings' page (Configuration tab > VoIP menu > SBC submenu >
General Settings).
Figure 3-103: General Settings Page
2. Configure the parameters as required.
To Next Page
Loading...
