AudioCodes Mediant 800 MSBG - Viewing IP Connectivity; Table 3-46: IP Connectivity Parameters

SIP User's Manual 356 Document #: LTRT-12804
Mediant 800 MSBG
3.5.2.7 Viewing IP Connectivity
The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Outbound IP Routing Table'
page (see ''Configuring Outbound IP Routing Table'' on page 165).
Notes:
• This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (see ''Configuring General Routing
Parameters'' on page 164) is set to 1 (Enable) or 2 (Status Only).
• The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
¾ To view IP connectivity information:
1. In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel
to IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2].
2. Open the 'IP Connectivity' page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Figure 3-311: IP Connectivity Page
Table 3-46: IP Connectivity Parameters
Column Name Description
IP Address
The IP address can be one of the following:
 IP address defined as the destination IP address in the 'Outbound IP
Routing Table'.
 IP address resolved from the host name defined as the destination IP
address in the 'Outbound IP Routing Table'.
Host Name
Host name (or IP address) as defined in the 'Outbound IP Routing Table'.
Connectivity
Method
The method according to which the destination IP address is queried
periodically (ICMP ping or SIP OPTIONS request).
Connectivity
Status
The status of the IP address' connectivity according to the method in the
'Connectivity Method' field.
 OK = Remote side responds to periodic connectivity queries.
 Lost = Remote side didn't respond for a short period.