AudioCodes Mediant 800 MSBG - Figure 3-41: IP Routing Table Page; Table 3-12: IP Routing Table Description

SIP User's Manual 88 Document #: LTRT-12804
Mediant 800 MSBG
3.3.2.1.2 Configuring the IP Routing Table
The 'IP Routing Table' page allows you to define up to 30 static IP routing rules for the
device. These rules can be associated with a network interface (defined in the Multiple
Interface table) and therefore, the routing decision is based on the source subnet/VLAN. If
not associated with an IP interface, the static IP rule is based on destination IP address.
¾ To configure static IP routing:
1. Open the 'IP Routing Table' page (Configuration tab > VoIP menu > Network
submenu > IP Routing Table).
Figure 3-41: IP Routing Table Page
2. In the 'Add a new table entry' table, add a new static routing rule according to the
parameters described in the table below.
3. Click Add New Entry; the new routing rule is added to the IP routing table.
To delete a routing rule from the table, select the 'Delete Row' check box corresponding to
the required routing rule, and then click Delete Selected Entries.
Notes:
• You can delete only inactive routing rules.
• You can also configure the IP Routing table using the ini file table
parameter StaticRouteTable.
Table 3-12: IP Routing Table Description
Parameter Description
Destination IP Address
[StaticRouteTable_Destination]
Specifies the IP address of the destination host/network.
Prefix Length
[StaticRouteTable_PrefixLength]
Specifies the subnet mask of the destination host/network.