AudioCodes Mediant 800 MSBG - Figure 8-64: Srds for LAN and WAN in SRD Table

Version 6.2 551 February 2011
SIP User's Manual 8. IP Telephony Capabilities
b. In the 'Media Realm' field, enter "LanMediaR". Note: This string must be
identical (and case-sensitive) as that defined in the 'SIP Media Realm' table
(see Step 1.b).
c. Click Apply.
c. Add SRD #1 for WAN:
a. In the 'Name' field, enter "WanSRD".
b. In the 'Media Realm' field, enter "WanMediaR". Note: This string must be
identical (and case-sensitive) as that defined in the 'SIP Media Realm' table
(see Step 1.c).
c. Click Apply.
Figure 8-64: SRDs for LAN and WAN in SRD Table
3. Configure SIP signaling interfaces for the SBC application for both legs (LAN and
WAN):
a. Open the 'SIP Interface Table' page (Configuration tab > VoIP menu > Control
Network submenu > SIP Interface Table).
b. Add a SIP Interface for LAN:
a. In the 'Network Interface' field, enter "Voice". Note: This string must be
identical (and case-sensitive) as that defined in the 'Multiple Interface' table
for the 'Interface Name' field (see ''Step 1: Configure LAN VoIP IP Address''
on page 547).
b. From the 'Ap
plication Type' drop-down list, select 'SBC'.
c. Define the UDP, TCP, and TLS ports as 5080, 5080, and 5081 respectively.
d. In the 'SRD' field, enter '0'. This associates the SIP interface with the LAN
SRD you defined in Step 2.b.
e. Click Apply.
c. Add a SIP Interface for WAN:
a. In the 'Network Interface' field, enter "WAN". Note: This string is case-
sensitive and represents the WAN IP address.
b. From the 'Application Type' drop-down list, select 'SBC'.
c. Define the UDP, TCP, and TLS ports as 5060, 5060, and 5061 respectively.
d. In the 'SRD' field, enter '1'. This associates this SIP interface with the WAN
SRD you defined in Step 2.c.
e. Click Apply.
Figure 8-65: LAN and WAN SIP Interfaces in the SIP Interface Table