SIP User's Manual 826 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
ToneIndex 1 = 1, 2, 20*, , 3;
Notes:
You can define up to 50 indices.
This parameter is applicable only to FXS interfaces.
Typically, the Ringing and/or Call Waiting tone played is
indicated in the SIP Alert-Info header field of the received
INVITE message. If this header is not present, then the tone
played is according to the settings of this table.
For depicting a range of FXS ports, use the syntax x-y (e.g.,
"1-4" for ports 1 through 4).
You can configure multiple entries with different source and/or
destination prefixes and tones for the same FXS port.
12.12.9.2 Tone Detection Parameters
The signal tone detection parameters are described in the table below.
Table 12-58: Tone Detection Parameters
Parameter Description
EMS: DTMF Enable
[DTMFDetectorEnable]
Enables or disables the detection of DTMF signaling.
[0] = Disable
[1] = Enable (default)
EMS: MF R1 Enable
[MFR1DetectorEnable]
Enables or disables the detection of MF-R1 signaling.
[0] = Disable (default)
[1] = Enable
EMS: R1.5 Detection Standard
[R1DetectionStandard]
Determines the MF-R1 protocol used for detection.
[0] = ITU (default)
[1] = R1.5
Note: For this parameter to take effect, a device reset is
required.
EMS: User Defined Tone Enable
[UserDefinedToneDetectorEnable]
Enables or disables the detection of User Defined Tones
signaling, applicable for Special Information Tone (SIT)
detection.
[0] = Disable (default)
[1] = Enable
EMS: SIT Enable
[SITDetectorEnable]
Enables or disables SIT detection according to the ITU-T
recommendation E.180/Q.35.
[0] = Disable (default).
[1] = Enable.
To disconnect IP-to-ISDN calls when a SIT tone is detected,
the following parameters must be configured:
SITDetectorEnable = 1
UserDefinedToneDetectorEnable = 1
To Next Page
Loading...
