Version 6.2 775 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
Notes:
If this parameter is disabled and the PSTN side remains in off-hook
state after the IP call ends the call, the device releases the call after 60
seconds.
A special CAS table can be used to report call status events
(Active/Idle) to the PSTN side during Cut Through mode.
The Digital Cut-Through feature can also be configured as a Tel Profile
(using the TelProfile parameter) and therefore, assigned to specific B-
channels that use specific CAS tables.
12.12.5.10 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 12-47: Automatic Dialing Parameters
Parameter Description
Web: Automatic Dialing Table
EMS: SIP Endpoints > Auto Dial
[TargetOfChannel]
This ini file table parameter defines telephone numbers that are
automatically dialed when a specific FXS or FXO port is used (i.e.,
telephone is off-hooked). The format of this parameter is as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
Where,
Destination = Destination phone number that you want dialed.
Type:
9 [0] Disable = automatic dialing is disabled.
9 [1] Enable = Destination phone number is automatically dialed if
phone is off-hooked (for FXS interface) or ring signal is applied to
port (FXO interface).
9 [2] Hotline = enables the Hotline feature where if the phone is off-
hooked and no digit is pressed for a user-defined duration
(configured by the parameter HotLineToneDuration), the
destination phone number is automatically dialed.
Module = Module number (where 1 depicts the module in Slot 1).
Port = Port number (where 1 depicts the Port 1 of the module).
HotLineToneDuration = if Hotline is enabled and the phone (connected
to the specific port) is off-hooked and no digit is pressed for this user-
defined duration (timeout), the device automatically initiates a call to the
user-defined destination phone number. The value range is 0 to 60
seconds, with default as 16. Note that you can use the "global"
HotLineToneDuration parameter to define this interval for all ports.
For example, the below configuration defines automatic dialing of phone
number 911 when the phone that is connected to Port 1 of Module 1 is off-
To Next Page
Loading...
