Version 6.2 569 February 2011
SIP User's Manual 8. IP Telephony Capabilities
3. Add an entry for G.711 and another entry for G.729.
Figure 8-82: Configuring the Coder Group
8.4.10.4.2 Step 2: Define an IP Profile
The procedure below describes how to configure an IP Profile. You need to assign to this
IP Profile the Coder Group #1 that you defined in ''Step 1: Define a Coder Group'' on page
568.
¾ To configure an IP Profile:
1. Open the 'IP Profile Settings' page (Configuration tab > VoIP menu > Coders And
Profiles submenu > IP Profile Settings).
2. From the 'Profile ID' drop-down list, select '1'.
3. Under the SBC group, from the 'Extension Coders Group ID' drop-down list, select
'Coders Group 1'.
Figure 8-83: Configuring the IP Profile for Coder Transcoding
4. Click Submit.
5. Save the settings to flash memory ("burn") and reset the device (see ''Saving
Configuration'' on page 336).
To Next Page
Loading...
