SIP User's Manual 118 Document #: LTRT-12804
Mediant 800 MSBG
¾ To configure the SIP Interface table:
1. Open the 'SIP Interface Table' page (Configuration tab > VoIP menu > Control
Network submenu > SIP Interface Table).
Figure 3-63: SIP Interface Table Page
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
Table 3-17:
SIP Interface Table Parameters
Parameter Description
Network Interface
[SIPInterface_NetworkInterface]
Corresponding IP network interface name, as configured in the
'Multiple Interface' table (InterfaceTable).
The default is "Not Configured".
Notes:
The value of this parameter must be identical (including case-
sensitive) to that configured for the 'Interface Name' in the
'Multiple Interface' table (see ''Configuring IP Interface
Settings'' on page 83).
To create a SIP interface on the WAN interface, enter the
string "WAN". This WAN interface is selected in the 'Multiple
Interface' table (see Configuring IP Interface Settings on page
83 or u
se the WANInterfaceName parameter), which is the
WAN interface address as defined in WAN Access Settings on
page 224. If
VLANs are defined for the WAN interface and
one of the VLANs is selected as the VoIP WAN interface, then
the defined SIP Interface uses this interface.
Application Type
[SIPInterface_ApplicationType]
Determines the application type associated with the SIP
Interface.
[0] GW/IP2IP (default) = IP-to-IP routing application and
regular gateway functionality
[1] SAS = Stand-Alone Survivability (SAS) application
[2] SBC = SBC application
Note: The IP-to-IP application will be supported in the next
applicable release.
UDP Port
[SIPInterface_UDPPort]
Determines the listening and source UDP port.
The valid range is 1 to 65534. The default is 5060.
Note: This port must be outside of the RTP port range.
To Next Page
Loading...
