SIP User's Manual 78 Document #: LTRT-12804
Mediant 800 MSBG
3.3.1.6.5 Configuring RADIUS Settings
The 'RADIUS Settings' page is used for configuring the Remote Authentication Dial In User
Service (RADIUS) accounting parameters. For a description of these parameters, see
''Configuration Parameters Reference'' on page 653.
¾ To configure RADIUS:
1. Open the ‘RADIUS Settings' page (Configuration tab > System menu >
Management submenu > RADIUS Settings).
Figure 3-35: RADIUS Parameters Page
2. Configure the parameters as required.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
3.3.1.6.6 SNMP Settings
The SNMP submenu includes the following items:
SNMP Community Settings (see ''Configuring SNMP Community Strings'' on page 78)
SNMP Tra
p Destinations (see ''Configuring SNMP Trap Destinations'' on page 80)
SNMP Tru
sted Managers (see ''Configuring SNMP Trusted Managers'' on page 81)
SNMP V3 Users
(see ''Configuring SNMP V3 Users'' on page 81)
3.3.1.6.6.1 Configuring SNMP Community Strings
The 'SNMP Community String' page allows you to configure up to five read-only and up to
five read-write SNMP community strings, and to configure the community string that is
used for sending traps. For detailed information on SNMP community strings, refer to the
Product Reference Manual. For detailed description on the SNMP parameters, see ''SNMP
Parameters'' on page 679.
To Next Page
Loading...
