AudioCodes Mediant 800 MSBG - Configuring Data-Routing LAN Interface; Figure 2-1: Connections Page; Figure 2-2: Defining LAN Data Routing IP Address; Table 2-1: Default LAN Data-Routing IP Address

SIP User's Manual 28 Document #: LTRT-12804
Mediant 800 MSBG
2.2.1.1 Configuring Data-Routing LAN Interface
The default IP addresses of the LAN data-routing interface is listed in the table below.
Table 2-1: Default LAN Data-Routing IP Address
Parameter Default Value
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Note: The data-routing interface's IP address must be in the same subnet as the
VoIP and Management interface.
¾ To define the device's LAN data-routing IP address:
1. Access the 'Connections' page (Configuration tab > Data menu > Data System >
Connections).
Figure 2-1: Connections Page
2. Click the Edit
button corresponding to the "LAN Switch VLAN 1" connection, and
then click the Settings tab.
3. In the 'IP Address' and 'Subnet Mask' fields, enter the required IP address and subnet
respectively.
Figure 2-2: Defining LAN Data Routing IP Address
4. Click OK to save your settings.