SIP User's Manual 278 Document #: LTRT-12804
Mediant 800 MSBG
Notes:
• Only default route devices can participate in load balancing.
• DSCP-based policy routing takes precedence over load balancing. If
most of the traffic falls under the DSCP-based policy routing rules, it is
then forwarded accordingly, regardless of the load balancing. Load
balancing, in this case, is by best-effort load balancing, and balances the
remaining traffic not directed by the DSCP-based policy routing rules.
¾ To configure general routes:
1. Click the General Routing item (Configuration tab > Data menu > Data Routing
submenu > General Routing); the following page appears:
Figure 3-194: Configuring General Routing
To view additional parameters on the page, click the Advanced button.
2. To add a new routing rule:
a. Under the 'Routing Table' group, click the New Route link; the following page
appears:
Figure 3-195: Adding a Routing Rule
b. Define the following fields:
♦ Name: select the network device.
♦ Destination: enter the destination host, subnet address, network address, or
default route. The destination for a default route is 0.0.0.0.
To Next Page
Loading...
