AudioCodes Mediant 800 MSBG - Figure 8-97: SIP Header Manipulation Example

Version 6.2 581 February 2011
SIP User's Manual 8. IP Telephony Capabilities
The manipulation rule is shown in the figure below:
Figure 8-97: SIP Header Manipulation Example
4. Click Apply.
8.4.10.8.2 Step 2: Assign Message Manipulation Rule to IP Group
The procedure below describes how to assign the configured SIP message manipulation
rule (rule #1) to the IP Group belonging to the LAN users.
¾ To add the SIP message manipulation rule to the IP Group:
1. Open the 'IP Group Table' page (Configuration tab > VoIP menu > Control Network
submenu > IP Group Table).
2. In the 'Inbound Message Manipulation Set' field, enter "1" to assign the Message
Manipulation Rule #1 that you configured in ''Step 1: Add SIP Message Manipulation
Rule'' on page 580.
Figure 8-98:
Assigning Manipulation Rule to IP Group
3. Click Submit.