SIP User's Manual 670 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
[RAILowThreshold]
Low threshold percentage of total calls that are active (busy endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default value is 90%.
[RAILoopTime]
Time interval (in seconds) that the device periodically checks call
resource availability.
The valid range is 1 to 200. The default is 10.
12.3.4 Serial Parameters
The RS-232 serial parameters are described in the table below. (Serial interface is mainly
used for debugging.)
Table 12-15: Serial Parameters
Parameter Description
[DisableRS232]
Enables or disables the device's RS-232 port.
[0] = RS-232 serial port is enabled.
[1] = RS-232 serial port is disabled (default).
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For information on
establishing a serial communications link with the device, refer to the
Installation Manual.
Note: For this parameter to take effect, a device reset is required.
EMS: Baud Rate
[SerialBaudRate]
Determines the value of the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For this parameter to take effect, a device reset is required.
EMS: Data
[SerialData]
Determines the value of the RS-232 data bit.
[7] = 7-bit.
[8] = 8-bit (default).
Note: For this parameter to take effect, a device reset is required.
EMS: Parity
[SerialParity]
Determines the value of the RS-232 polarity.
[0] = None (default).
[1] = Odd.
[2] = Even.
Note: For this parameter to take effect, a device reset is required.
EMS: Stop
[SerialStop]
Determines the value of the RS-232 stop bit.
[1] = 1-bit (default).
[2] = 2-bit.
Note: For this parameter to take effect, a device reset is required.
To Next Page
Loading...
