AudioCodes Mediant 800 MSBG - C All Waiting Parameters

SIP User's Manual 762 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
response includes the P-Asserted-Identity with Caller ID. The
device interworks (in some ISDN variants), the Connected
Party number and name from Q.931 Connect message to SIP
200 OK with the P-Asserted-Identity header. In the opposite
direction, if the ISDN device receives a 200 OK with P-
Asserted-Identity header, it interworks it to the Connected party
number and name in the Q.931 Connect message, including its
privacy.
Web: Use Destination As
Connected Number
[UseDestinationAsConnectedNu
mber]
Determines whether the device includes the Called Party
Number from outgoing Tel calls (after number manipulation) in
the SIP P-Asserted-Identity header. The device includes the
SIP P-Asserted-Identity header in 180 Ringing and 200 OK
responses for IP-to-Tel calls.
 [0] Disable (default)
 [1] Enable
Notes:
 For this feature, you must also enable the device to include
the P-Asserted-Identity header in 180/200 OK responses,
by setting the parameter AssertedIDMode to 1.
 This parameter is applicable to ISDN, CAS, and/or FXO
interfaces.
Web: Caller ID Transport Type
EMS: Transport Type
[CallerIDTransportType]
Determines the device's behavior for Caller ID detection.
 [0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.
 [1] Relay = (Currently not applicable.)
 [3] Mute = The caller ID signal is detected from the
Tel/PSTN side and then erased from the voice stream
(default).
Note: Caller ID detection is applicable only to FXO interfaces.
12.12.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.
Table 12-39: Call Waiting Parameters
Parameter Description
Web/EMS: Enable Call Waiting
[EnableCallWaiting]
Determines whether Call Waiting is enabled.
 [0] Disable = Disable the Call Waiting service.
 [1] Enable = Enable the Call Waiting service (default).
If enabled, when an FXS interface receives a call on a busy
endpoint, it responds with a 182 response (and not with a 486
busy). The device plays a call waiting indication signal. When
hook-flash is detected, the device switches to the waiting call.
The device that initiated the waiting call plays a Call Waiting
Ringback tone to the calling party after a 182 response is
received.
Notes: