Version 6.2 561 February 2011
SIP User's Manual 8. IP Telephony Capabilities
5. Define the UDP, TCP, and TLS ports as 5070, 5070, and 5071 respectively.
6. In the 'SRD' field, enter '0'. This associates the SIP interface with the LAN SRD you
defined ''Step 5: Configure Multiple SIP and RTP Interfaces'' on page 550.
Figure 8-75:
Configuring SIP Interface for PSTN (GW)
7. Click Apply.
8.4.10.3.2 Step 2: Define Device as a Proxy Set
The procedure below describes how to configure the device's LAN SBC interface (i.e.,
10.8.6.86) as a Proxy Set. This Proxy Set is later associated with the IP Group #3 for
PSTN calls in ''Step 3: Define IP Group for PSTN'' on page 562.
¾ To configure the device's LAN SBC as a Proxy Set:
1. Open the 'Proxy Sets Table' page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
2. From the 'Proxy Set ID' drop-down list, select '2'.
3. In the 'Proxy Address' field, enter 10.8.6.86, and then from the 'Transport Type' drop-
down list, select 'UDP' as the transport type.
To Next Page
Loading...
