SIP User's Manual 858 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: LDAP Server Max Respond
Time
[LDAPServerMaxRespondTime]
Defines the time (in seconds) that the device waits for LDAP
server responses.
The valid value range is 0 to 86400. The default is 3000.
[LDAPDebugMode]
Determines whether to enable the LDAP task debug
messages. This is used for providing debug information
regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.
Web: MS LDAP OCS Number
attribute name
[MSLDAPOCSNumAttributeName]
The name of the attribute that represents the user OCS
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default
is "msRTCSIP-PrimaryUserAddress".
Web: MS LDAP PBX Number attribute
name
[MSLDAPPBXNumAttributeName]
The name of the attribute that represents the user PBX
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default
is "telephoneNumber".
Web: MS LDAP MOBILE Number
attribute name
[MSLDAPMobileNumAttributeName]
The name of the attribute that represents the user Mobile
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default
is "mobile".
12.13 SBC Parameters
The SBC parameters are described in the table below.
Table 12-67: SBC Parameters
Parameter Description
Web: Enable SBC
EMS: Enable ISBC
[EnableSBCApplication]
Enables the Session Border Control (SBC) application.
[0] Disable (default)
[1] Enable
Notes:
For this parameter to take effect, a device reset is
required.
In addition to enabling this parameter, the number of
maximum SBC/IP-to-IP sessions must be defined in the
Software Upgrade Key.
WAN Interface Name
[WanInterfaceName]
Defines the WAN interface for the VoIP interface. The
available interface options depends on the hardware
configuration (e.g., Ethernet, T1, or SHDSL) and/or whether
VLANs are defined for the WAN interface (see Virtual LAN
Interface (VLAN) on page 301).
The value mus
t be enclosed in single quotation marks ('...'),
for example, WanInterfaceName = 'GigabitEthernet 0/0'.
This WAN interface can be assigned to SIP signaling and/or
media interfaces, in the SIP Interface table, where it is
represented as "WAN" (see Configuring SIP Interface Table
on page 117). If VLANs are config
ured, for example, for the
Ethernet WAN interface (see Data Settings on page 222),
To Next Page
Loading...
