AudioCodes Mediant 800 MSBG - SIP Definitions

SIP User's Manual 130 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
HotSwapRtx), the message is resent to the next redundant
Proxy/Registrar server.
Web/EMS: Redundancy Mode
[ProxySet_ProxyRedundancyM
ode]
Determines whether the device switches back to the primary
Proxy after using a redundant Proxy (per this Proxy Set).
 [-1] = Not configured – the “global” parameter
ProxyRedundancyMode applies (default).
 [0] Parking = The device continues operating with a redundant
(now active) Proxy until the next failure, after which it operates
with the next redundant Proxy.
 [1] Homing = The device always attempts to operate with the
primary Proxy server (i.e., switches back to the primary Proxy
whenever it's available).
Notes:
 To use the Proxy Redundancy mechanism, you need to
enable the keep-alive with Proxy option, by setting the
parameter EnableProxyKeepAlive to 1 or 2.
 If this parameter is configured, then the global parameter is
ignored.
Web/EMS: SRD Index
[ProxySet_ProxySet_SRD]
The SRD (defined in Configuring SRD Table on page 114)
associated with the Proxy Set ID.
Notes:
 For this parameter to take effect, a device reset is required.
 If no SRD is defined for this parameter, by default, SRD ID #0
is associated with the Proxy Set.
Web/EMS: Classification Input
[ClassificationInput]
Classifies an IP call to a Proxy Set, based on either its IP
address, or based on its IP address, port, and transport type:
 [0] Compare only IP = IP call classified to Proxy Set according
to IP address only (default).
 [1] Compare IP, port and transport type = IP call classified to
Proxy Set according to IP address, port, and transport type.
3.3.2.9 SIP Definitions
The SIP Definitions submenu allows you to configure various SIP call control settings.
This menu contains the following page items:
 General Parameters (see ''Configuring SIP General Parameters'' on page 130)
 Adv
anced Parameters (see ''Configuring Advanced Parameters'' on page 132)
 Acco
unt Table (see Configuring Account Table on page 133)
 Proxy & Registration
(see ''Configuring Proxy and Registration Parameters'' on page
136)
3.3.2.9.1 Configuring SIP General Parameters
The 'SIP General Parameters' page is used to configure general SIP parameters. For a
description of the parameters appearing on this page, see ''Configuration Parameters
Reference'' on page 653.