AudioCodes Mediant 800 MSBG - DNS Parameters

Version 6.2 659 February 2011
SIP User's Manual 12. Configuration Parameters Reference
12.1.6 DNS Parameters
The Domain name System (DNS) parameters are described in the table below.
Table 12-6: DNS Parameters
Parameter Description
Web: DNS Primary Server
IP
EMS: DNS Primary Server
[DNSPriServerIP]
The IP address of the primary DNS server. Enter the IP address in
dotted-decimal notation, for example, 10.8.2.255.
Notes:
 For this parameter to take effect, a device reset is required.
 To use Fully Qualified Domain Names (FQDN) in the 'Outbound IP
Routing Table', you must define this parameter.
Web: DNS Secondary
Server IP
EMS: DNS Secondary
Server
[DNSSecServerIP]
The IP address of the second DNS server. Enter the IP address in
dotted-decimal notation, for example, 10.8.2.255.
Note: For this parameter to take effect, a device reset is required.
Web: Internal DNS Table
EMS: DNS Information
[DNS2IP]
This ini file table parameter configures the internal DNS table for
resolving host names into IP addresses. Up to four different IP
addresses (in dotted-decimal notation) can be assigned to a host name.
The format of this parameter is as follows:
[Dns2Ip]
FORMAT Dns2Ip_Index = Dns2Ip_DomainName,
Dns2Ip_FirstIpAddress, Dns2Ip_SecondIpAddress,
Dns2Ip_ThirdIpAddress, Dns2Ip_FourthIpAddress;
[\Dns2Ip]
For example:
Dns2Ip 0 = DnsName, 1.1.1.1, 2.2.2.2, 3.3.3.3, 4.4.4.4;
Notes:
 This parameter can include up to 20 indices.
 If the internal DNS table is used, the device first attempts to resolve a
domain name using this table. If the domain name isn't found, the
device performs a DNS resolution using an external DNS server.
 To configure the internal DNS table using the Web interface and for a
description of the parameters in this ini file table parameter, see
''Configuring the Internal DNS Table'' on page 91.
 For an explanation on using ini file table parameters, see ''Configuring
ini File Table Parameters'' on page 368.
Web: Internal SRV Table
EMS: DNS Information
[SRV2IP]
This ini file table parameter defines the internal SRV table for resolving
host names into DNS A-Records. Three different A-Records can be
assigned to a host name. Each A-Record contains the host name,
priority, weight, and port. The format of this parameter is as follows:
[SRV2IP]