Version 6.2 477 February 2011
SIP User's Manual 8. IP Telephony Capabilities
3. In the 'IP Group Table' page (see ''Configuring IP Groups'' on page 119), configu
re the
two IP Groups #1 and #2. Assign Proxy Sets #1 and #2 to IP Groups #1 and #2
respectively.
Figure 8-40: Configuring IP Groups #1 and #2 in the IP Group Table Page
4. In the 'Hunt Group Table' page, enable the Trunks connected between the
Enterprise's PBX and the device (Hunt Group ID #1), and between the local PSTN and
the device (Hunt Group ID #2).
Figure 8-41: Assigning Channels to Hunt Groups
5. In the 'Hunt Group Settings' page, configure 'Per Account' registration for Hunt Group
ID #1 (without serving IP Group) and associate it with IP Group #1; Configure 'Per
Endpoint' registration for Hunt Group ID #2 and associated it with IP Group #2.
Figure 8-42: Configuring Registration Mode for Hunt Groups and Assigning to IP Group
6. In the 'Authentication' page, for channels 5-8 (i.e., Hunt Group ID #2), define for each
channel the registration (authentication) user name and password.
Figure 8-43: Configuring Username and Password for Authenticating Channels 5-8
To Next Page
Loading...
