AudioCodes Mediant 800 MSBG - Figure 3-78: Redirect Number IP to Tel Page; Table 3-24: Redirect Number IP to Tel Parameters Description

Version 6.2 157 February 2011
SIP User's Manual 3. Web-Based Management
¾ To configure Redirect Number IP-to-Tel manipulation rules:
1. Open the 'Redirect Number IP > Tel' page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Manipulations submenu > Redirect Number IP > Tel).
Figure 3-78: Redirect Number IP to Tel Page
2. Configure the rules according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
Table 3-24:
Redirect Number IP to Tel Parameters Description
Parameter Description
Web/EMS: Destination
Prefix
Destination (called) telephone number prefix. An asterisk (*) represents
any number.
Web/EMS: Redirect Prefix Redirect telephone number prefix. An asterisk (*) represents any
number.
Web: Stripped Digits From
Left
EMS: Remove From Left
Number of digits to remove from the left of the telephone number prefix.
For example, if you enter 3 and the phone number is 5551234, the new
phone number is 1234.
Web: Stripped Digits From
Right
EMS: Remove From Right
Number of digits to remove from the right of the telephone number
prefix. For example, if you enter 3 and the phone number is 5551234,
the new phone number is 5551.
Web/EMS: Prefix to Add The number or string that you want added to the front of the telephone
number. For example, if you enter '9' and the phone number is 1234,
the new number is 91234.
Web/EMS: Suffix to Add The number or string that you want added to the end of the telephone
number. For example, if you enter '00' and the phone number is 1234,
the new number is 123400.
Web/EMS: Number of
Digits to Leave
The number of digits that you want to retain from the right of the phone
number.
Web: Presentation
EMS: Is Presentation
Restricted
Determines whether Caller ID is permitted:
 Not Configured = Privacy is determined according to the Caller ID
table (see ''Configuring Caller Display Information'' on page 185).
 [0] Allowed = Sends Caller ID information when a call is made using
these destination / source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Notes:
 If 'Presentation' is set to 'Restricted' and the AssertedIdMode