AudioCodes Mediant 800 MSBG - Page 336

SIP User's Manual 336 Document #: LTRT-12804
Mediant 800 MSBG
5. Click OK to confirm device Lock; if 'Graceful Option' is set to 'Yes', the lock is delayed
and a screen displaying the number of remaining calls and time is displayed.
Otherwise, the lock process begins immediately. The 'Current Admin State' field
displays the current state: LOCKED or UNLOCKED.
¾ To unlock the device:
1. Open the 'Maintenance Actions' page (see ''Maintenance Actions'' on page 333).
2. U
nder the 'LOCK / UNLOCK' group, click the UNLOCK button. Unlock starts
immediately and the device accepts new incoming calls.
Note: The Home page's General Information pane displays whether the device is
locked or unlocked (see ''Using the Home Page'' on page 59).
3.4.1.1.3 Saving Configuration
The 'Maintenance Actions' page allows you to save (burn) the current parameter
configuration (including loaded auxiliary files) to the device's non-volatile memory (i.e.,
flash). The parameter modifications that you make throughout the Web interface's pages
are temporarily saved (to the volatile memory - RAM) when you click the Submit button on
these pages. Parameter settings that are saved only to the device's RAM, revert to their
previous settings after a hardware/software reset (or power failure). Therefore, to ensure
that your configuration changes are retained, you must save them to the device's flash
memory using the burn option described below.
¾ To save the changes to the non-volatile flash memory :
1. Open the 'Maintenance Actions' page (see ''Maintenance Actions'' on page 333).
2. Und
er the 'Save Configuration' group, click the BURN button; a confirmation message
appears when the configuration successfully saves.
Notes:
• Saving configuration to the non-volatile memory may disrupt current
traffic on the device. To avoid this, disable all new traffic before saving,
by performing a graceful lock (see ''Locking and Unlocking the Device''
on page 335).
• Throughout the Web interface, parameters preceded by the lightning
symbol are not applied on-the-fly and require that you reset the device for
them to take effect (see ''Resetting the Device'' on page 334).
• The Home page's General Information pane displays whether the device
is currently "burning" the configuration (see ''Using the Home Page'' on
page 59).