SIP User's Manual 392 Document #: LTRT-12804
Mediant 800 MSBG
The CLI commands are shown in the terminal emulation program (e.g., HyperTerminal)
below:
6.2 Restoring Defaults using an ini File
You can restore the device to factory default settings by loading an empty ini file to the
device, using the Web interface's 'Configuration File' page (see ''Backing Up and Loading
Configuration File'' on page 344). The o
nly settings that are not restored to default are the
management (OAMP) LAN IP address and the Web interface's login user name and
password. The loaded ini file must be empty (i.e., contain no parameters), or include only
comment signs (i.e., semicolons ";") preceding lines (parameters). The default values
assigned to the parameters are according to the cmp file running on the device.
6.3 Restoring Defaults using Hardware Reset Button
The device's hardware Reset pinhole button can be used to reset the device to default
settings. For a detailed description, refer to the Installation Manual.
To Next Page
Loading...
