Version 6.2 381 February 2011
SIP User's Manual 5. EMS-Based Management
4. Select the Registration tab.
a. Configure 'Is Register Needed' field:
♦ No = the device doesn't register to a Proxy/Registrar server (default).
♦ Yes = the device registers to a Proxy/Registrar server at power up and every
user-defined interval (‘Registration Time’ parameter).
b. Click Apply and close the active window.
5. Open the 'SIP EndPoints' frame (Configuration pane > SIP Endpoints menu).
a. Click the
button to add a new entry, and then click Yes to confirm; the
'Phones' screen is displayed.
b. Double-click each field to enter values.
c. Right-click the new entry, and then select Unlock Rows.
d. Click Apply and close the active window.
Note: For T1 ISDN spans, configure 1-23 (and not 1-24) for B-channels. Channel
24 is a signaling ISDN channel.
6. If a Proxy Server is not implemented, map outgoing telephone calls to IP addresses.
Open the 'SIP Routing' frame (Configuration pane > SIP Routing menu).
a. Select the Tel to IP tab.
b. Click the
button to add a new entry, and then click Yes to confirm; the Tel to IP
Routing table is displayed.
c. Double-click each field to enter values.
d. Right-click the new entry and select Unlock Rows.
e. Click Apply and close the active window.
To Next Page
Loading...
