AudioCodes Mediant 800 MSBG - Page 736

SIP User's Manual 736 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: Fax/Modem Bypass
Packing Factor
EMS: Packetization Period
[FaxModemBypassM]
Number of (20 msec) coder payloads that are used to generate a
fax/modem bypass packet.
The valid range is 1, 2, or 3 coder payloads. The default value is
1 coder payload.
[FaxModemNTEMode]
Determines whether the device sends RFC 2833 ANS/ANSam
events upon detection of fax and/or modem Answer tones (i.e.,
CED tone).
 [0] = Disabled (default).
 [1] = Enabled.
Note: This parameter is applicable only when the fax or modem
transport type is set to bypass or Transparent-with-Events.
Web/EMS: Fax Bypass Payload
Type
[FaxBypassPayloadType]
Determines the fax bypass RTP dynamic payload type.
The valid range is 96 to 120. The default value is 102.
EMS: Modem Bypass Payload
Type
[ModemBypassPayloadType]
Modem Bypass dynamic payload type.
The range is 0-127. The default value is 103.
EMS: Relay Volume (dBm)
[FaxModemRelayVolume]
Determines the fax gain control.
The range is -18 to -3, corresponding to -18 dBm to -3 dBm in 1-
dB steps. The default is -6 dBm fax gain control.
Web/EMS: Fax Bypass Output
Gain
[FaxBypassOutputGain]
Defines the fax bypass output gain control.
The range is -31 to +31 dB, in 1-dB steps. The default is 0 (i.e.,
no gain).
Web/EMS: Modem Bypass
Output Gain
[ModemBypassOutputGain]
Defines the modem bypass output gain control.
The range is -31 dB to +31 dB, in 1-dB steps. The default is 0
(i.e., no gain).
EMS: NTE Max Duration
[NTEMaxDuration]
Maximum time for sending Named Telephony Events (NTEs) to
the IP side regardless of the time range when the TDM signal is
detected.
The range is -1 to 200,000,000 msec (i.e., 55 hours). The default
is -1 (i.e., NTE stops only upon detection of an End event).
EMS: Basic Packet Interval
[FaxModemBypassBasicRTPP
acketInterval]
Determines the basic frame size that is used during fax/modem
bypass sessions.
 [0] = Determined internally (default)
 [1] = 5 msec (not recommended)
 [2] = 10 msec
 [3] = 20 msec
Note: When set to 5 msec (1), the maximum number of
simultaneous channels supported is 120.
EMS: Dynamic Jitter Buffer
Minimal Delay (dB)
[FaxModemBypasDJBufMinDel
ay]
Determines the Jitter Buffer delay (in milliseconds) during fax and
modem bypass session.
The range is 0 to 150 msec. The default is 40.