AudioCodes Mediant 800 MSBG - Page 758

SIP User's Manual 758 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
From header.
The format of this parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted, CallerDisplayInfo_Module,
CallerDisplayInfo_Port;
[\CallerDisplayInfo]
Where,
 DisplayString = Caller ID string (up to 18 characters).
 IsCidRestricted =
9 [0] Allowed = sends the defined caller ID string when a
Tel-to-IP call is made using the corresponding device
port (default).
9 [1] Restricted = does not send the defined caller ID
string.
 Module = Module number (where 1 depicts the module in
Slot 1).
 Port = Port number (where 1 depicts Port 1 of a module).
For example:
CallerDisplayInfo 0 = Susan C.,0,1,1; ("Susan C." is sent as
the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2; ("Mark M." is sent as
Caller ID for Port 2 of Module 1)
Notes:
 The indexing of this ini file table parameter starts at 0.
 When FXS ports receive 'Private' or 'Anonymous' strings in
the SIP From header, the calling name or number is not
sent to the Caller ID display.
 If the Caller ID name is detected on an FXO line (the
parameter EnableCallerID is set to 1), it is used instead of
the Caller ID name defined in this table parameter.
 When the parameter CallerDisplayInfo_IsCidRestricted is
set to 1 (Restricted), the Caller ID is sent to the remote side
using only the SIP headers P-Asserted-Identity and P-
Preferred-Identity (AssertedIdMode).
 The value of the parameter
CallerDisplayInfo_IsCidRestricted is overridden by the
parameter
SourceNumberMapIp2Tel_IsPresentationRestricted in the
'Source Number Manipulation' table (table parameter
SourceNumberMapIP2Tel).
 For configuring this table using the Web interface, see
Configuring Caller Display Information on page 185.
 For an explanation on using ini file table parameters, see
Configuring ini File Table Parameters on page 368.