Version 6.2 811 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
Selection (TNS) IE.
If enabled, the CIC code (received in an INVITE Request-URI)
is included in a TNS IE in the ISDN Setup message.
For example: INVITE sip:555666;cic=2345@100.2.3.4 sip/2.0.
Notes:
This feature is supported only for SIP-to-ISDN calls.
The parameter AddCicAsPrefix can be used to add the CIC
as a prefix to the destination phone number for routing IP-to-
Tel calls.
EMS: Enable AOC
[EnableAOC]
Determines whether ISDN Advice of Charge (AOC) messages
are interworked to SIP.
[0] = Not used (default).
[1] = AOC messages are interworked to SIP.
The device supports the receipt of ISDN (Euro ISDN) AOC
messages. AOC messages can be received during a call
(Facility messages) or at the end of a call (Disconnect or
Release messages). The device converts the AOC messages
into SIP INFO (during a call) and BYE (end of a call) messages,
using a proprietary AOC SIP header. The device supports both
Currency and Pulse AOC messages.
Web: IPMedia Detectors
EMS: DSP Detectors Enable
[EnableDSPIPMDetectors]
Enables or disables the device's DSP detectors.
[0] = Disable (default).
[1] = Enable.
Notes:
For this parameter to take effect, a device reset is required.
The device's Software Upgrade Key must contain the
'IPMDetector' DSP option.
When enabled (1), the number of available channels is
reduced.
Web: Add IE in SETUP
EMS: IE To Be Added In Q.931
Setup
[AddIEinSetup]
Adds an optional Information Element (IE) data (in hex format)
to ISDN Setup messages. For example, to add IE
'0x20,0x02,0x00,0xe1', enter the value "200200e1".
Notes:
This IE is sent from the Hunt Group IDs that are defined by
the parameter SendIEonTG.
You can configure different IE data for Hunt Groups by
defining this parameter for different IP Profile IDs (using the
IPProfile parameter) and then assigning the required IP
Profile ID in the 'Inbound IP Routing Table' (PSTNPrefix).
Web: Trunk Groups to Send IE
EMS: List Of Trunk Groups To
Send IE
[SendIEonTG]
Defines Hunt Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is
sent. For example: '1,2,4,10,12,6'.
Notes:
You can configure different IE data for Hunt Groups by
defining this parameter for different IP Profile IDs (using the
parameter IPProfile), and then assigning the required IP
To Next Page
Loading...
