AudioCodes Mediant 800 MSBG - Page 830

SIP User's Manual 830 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
destination "123", the device collects and sends all the dialed
digits, including the prefix string, as "9123" to the IP destination
number.
Note: This parameter is applicable only to FXS interfaces.
Hook Flash Parameters
Web: Flash Keys Sequence Style
[FlashKeysSequenceStyle]
Hook flash keys sequence style for FXS interfaces.
 [0] 0 = Flash hook (default) - only the phone's Flash button
is used, according to the following scenarios:
9 During an existing call, if the user presses the Flash
button, the call is put on hold; a dial tone is heard and
the user is able to initiate a second call. Once the
second call is established, on-hooking transfers the first
(held) call to the second call.
9 During an existing call, if a call comes in (call waiting),
pressing the Flash button places the active call on hold
and answers the waiting call; pressing Flash again
toggles between these two calls.
 [1] 1 = Sequence of Flash hook and digit:
9 Flash + 1: holds a call or toggles between two existing
calls
9 Flash + 2: makes a call transfer.
9 Flash + 3: makes a three-way conference call (if the
Three-Way Conference feature is enabled, i.e., the
parameter Enable3WayConference is set to 1 and the
parameter 3WayConferenceMode is set to 2).
 [2] 2 = Sequence of Flash Hook and digit:
9 Flash Hook only: places a call on hold.
9 Flash + 2: places a call on hold and answers a call-
waiting call, or toggles between active and on-hold calls.
9 Flash + 3: makes a three-way conference call (if the
Enable3WayConference parameter is set to 1 and the
3WayConferenceMode parameter is set to 2). Note that
the settings of the ConferenceCode parameter are
ignored.
9 Flash + 4: makes a call transfer.
Web: Flash Keys Sequence
Timeout
[FlashKeysSequenceTimeout]
Flash keys sequence timeout - the time (in msec) that the
device waits for digits after the user presses the Flash button
(Flash Hook + Digit mode - when the parameter
FlashKeysSequenceStyle is set to 1 or 2).
The valid range is 100 to 5,000. The default is 2,000.
Keypad Feature - Call Forward Parameters
Web: Unconditional
EMS: Call Forward Unconditional
[KeyCFUnCond]
Keypad sequence that activates the immediate call forward
option.
Web: No Answer
EMS: Call Forward No Answer
[KeyCFNoAnswer]
Keypad sequence that activates the forward on no answer
option.
Web: On Busy
EMS: Call Forward Busy
[KeyCFBusy]
Keypad sequence that activates the forward on busy option.