SIP User's Manual 832 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
a mismatch, a reorder tone is played to the phone.
Notes:
This parameter is applicable to FXO and FXS interfaces (but
for FXO the Web interface does not display this parameter).
It is possible to configure whether the KeyBlindTransfer code
is added as a prefix to the dialed destination number, by
using the parameter KeyBlindTransferAddPrefix.
Keypad Feature - Call Waiting Parameters
Web: Activate
EMS: Keypad Features CW
[KeyCallWaiting]
Keypad sequence that activates the Call Waiting option. After
the sequence is pressed, a confirmation tone is heard.
Web: Deactivate
EMS: Keypad Features CW Deact
[KeyCallWaitingDeact]
Keypad sequence that deactivates the Call Waiting option. After
the sequence is pressed, a confirmation tone is heard.
Keypad Feature - Reject Anonymous Call Parameters
Web: Activate
EMS: Reject Anonymous Call
[KeyRejectAnonymousCall]
Keypad sequence that activates the reject anonymous call
option, whereby the device rejects incoming anonymous calls.
After the sequence is pressed, a confirmation tone is heard.
Web: Deactivate
EMS: Reject Anonymous Call
Deact
[KeyRejectAnonymousCallDeact]
Keypad sequence that de-activates the reject anonymous call
option. After the sequence is pressed, a confirmation tone is
heard.
[RejectAnonymousCallPerPort]
This ini file table parameter determines whether the device
rejects incoming anonymous calls on FXS interfaces. The
format of this parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable,
RejectAnonymousCallPerPort_Port,
RejectAnonymousCallPerPort_Module;
[\RejectAnonymousCallPerPort]
Where,
Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
Port = Port number.
Module = Module number.
For example:
RejectAnonymousCallPerPort 0 = 0,1,1;
RejectAnonymousCallPerPort 1 = 1,2,1;
If enabled, when a device's FXS interface receives an
anonymous call, it responds with a 433 (Anonymity Disallowed)
SIP response.
Notes:
This parameter is applicable only to FXS interfaces.
This parameter is per FXS port.
For an explanation on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
To Next Page
Loading...
