Version 6.2 837 February 2011
SIP User's Manual 12. Configuration Parameters Reference
Parameter Description
For example:
TrunkGroupSettings 0 = 1, 0, 5, branch-hq, user, 1, 255;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2, 255;
Notes:
This parameter can include up to 24 indices.
The parameter MWIInterrogationType is not applicable.
For configuring Hunt Group Settings using the Web interface,
see ''Configuring Hunt Group Settings'' on page 148.
For a description on using ini file table parameters, see to
''Configuring ini File Table Parameters'' on page 368.
Web: Channel Select Mode
EMS: Channel Selection Mode
[ChannelSelectMode]
Method for allocating incoming IP-to-Tel calls to a channel.
[0] By Dest Phone Number = Selects the device's channel
according to the called number (default.)
[1] Cyclic Ascending = Selects the next available channel in
an ascending cyclic order. Always selects the next higher
channel number in the Hunt Group. When the device reaches
the highest channel number in the Hunt Group, it selects the
lowest channel number in the Hunt Group and then starts
ascending again.
[2] Ascending = Selects the lowest available channel. It
always starts at the lowest channel number in the Hunt
Group and if that channel is unavailable, selects the next
higher channel.
[3] Cyclic Descending = Selects the next available channel in
descending cyclic order. It always selects the next lower
channel number in the Hunt Group. When the device reaches
the lowest channel number in the Hunt Group, it selects the
highest channel number in the Hunt Group and then starts
descending again.
[4] Descending = Selects the highest available channel. It
always starts at the highest channel number in the Hunt
Group and if that channel is unavailable, selects the next
lower channel.
[5] Dest Number + Cyclic Ascending = The device first
selects the channel according to the called number. If the
called number isn't found, it then selects the next available
channel in ascending cyclic order. Note that if the called
number is found but the port associated with this number is
busy, the call is released.
[6] By Source Phone Number = The device selects the
channel according to the calling number.
[7] Trunk Cyclic Ascending = The device selects the channel
from the first channel of the next trunk (adjacent to the trunk
from which the previous channel was allocated). This option
is applicable only to digital interfaces.
[8] Trunk & Channel Cyclic Ascending = The device
implements the Trunk Cyclic Ascending and Cyclic
Ascending methods to select the channel. This method
selects the next physical trunk (pertaining to the Hunt Group)
and then selects the B-channel of this trunk according to the
To Next Page
Loading...
