AudioCodes Mediant 800 MSBG - Page 840

SIP User's Manual 840 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
PREFIX_DestAddress, PREFIX_SourcePrefix,
PREFIX_ProfileId, PREFIX_MeteringCode, PREFIX_DestPort,
PREFIX_SrcIPGroupID, PREFIX_DestHostPrefix,
PREFIX_DestIPGroupID, PREFIX_SrcHostPrefix,
PREFIX_TransportType, PREFIX_SrcTrunkGroupID,
PREFIX_DestSRD;
[\PREFIX]
For example:
PREFIX 0 = *, domain.com, *, 0, 255, $$, -1, , 1, , -1, -1, -1;
PREFIX 1 = 20, 10.33.37.77, *, 0, 255, $$, -1, , 2, , 0, -1;
Notes:
 This parameter can include up to 200 indices.
 For a detailed description of the table's parameters and for
configuring this table using the Web interface, see
''Configuring Outbound IP Routing Table'' on page 165.
 For a description on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 368.
Web: Inbound IP Routing Table
EMS: SIP Routing > IP to Hunt
[PSTNPrefix]
This ini file table parameter configures the routing of IP calls to
Hunt Groups (or inbound IP Groups). The format of this
parameter is as follows:
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_DestPrefix,
PstnPrefix_TrunkGroupId, PstnPrefix_SourcePrefix,
PstnPrefix_SourceAddress, PstnPrefix_ProfileId,
PstnPrefix_SrcIPGroupID, PstnPrefix_DestHostPrefix,
PstnPrefix_SrcHostPrefix;
[\PSTNPrefix]
For example:
PstnPrefix 0 = 100, 1, 200, *, 0, 2, , ;
PstnPrefix 1 = *, 2, *, , 1, 3, acl, joe;
Notes:
 This parameter can include up to 24 indices.
 For a description of the table's parameters, refer to the
corresponding Web parameters in ''Configuring Inbound IP
Routing Table'' on page 172.
 To support the In-Call Alternative Routing feature, you can
use two entries that support the same call but assigned with
a different Hunt Group. The second entry functions as an
alternative route if the first rule fails as a result of one of the
release reasons configured in the AltRouteCauseIP2Tel
table.
 Selection of Hunt Groups (for IP-to-Tel calls) is according to
destination number, source number,and source IP address.
 The source IP address (SourceAddress) can include the 'x'
wildcard to represent single digits. For example: 10.8.8.xx
represents all IP addresses between 10.8.8.10 and
10.8.8.99.
 The source IP address (SourceAddress) can include the