AudioCodes Mediant 800 MSBG - Page 872

SIP User's Manual 872 Document #: LTRT-12804
Mediant 800 MSBG
Parameter Description
Web: IP to IP Outbound Manipulation Table
EMS: IP to IP Outbound Manipulation
[IPOutboundManipulation]
This ini file table parameter configures the IP to IP Outbound
Manipulation table. This table allows you to manipulate the
SIP URI user part (source and/or destination) of the outbound
SIP dialog message. The format of this parameter is as
follows:
[IPOutboundManipulation]
FORMAT IPOutboundManipulation_Index =
IPOutboundManipulation_IsAdditionalManipulation,
IPOutboundManipulation_ManipulatedURI,
IPOutboundManipulation_SrcIPGroupID,
IPOutboundManipulation_DestIPGroupID,
IPOutboundManipulation_SrcUsernamePrefix,
IPOutboundManipulation_SrcHost,
IPOutboundManipulation_DestUsernamePrefix,
IPOutboundManipulation_DestHost,
IPOutboundManipulation_RequestType,
IPOutboundManipulation_RemoveFromLeft,
IPOutboundManipulation_RemoveFromRight,
IPOutboundManipulation_LeaveFromRight,
IPOutboundManipulation_Prefix2Add,
IPOutboundManipulation_Suffix2Add,
IPOutboundManipulation_PrivacyRestrictionMode;
[\IPOutboundManipulation]
For example:
IPOutboundManipulation 1 = 0, 0, 2, -1, *, *, *, *, 1, 3, 0, 255,
, , 0;
Notes:
 This table can include up to 100 indices (where 0 is the
first index).
 Manipulated destination SIP URI user names are done on
the following SIP headers: Request URI, To, and Remote-
Party-ID (if exists). Manipulated source SIP URI user
names are done on the following SIP headers: From, P-
Asserted (if exists), P-Preferred (if exists), and Remote-
Party-ID (if exists).
 For SIP URI host name (source and destination)
manipulations, you can also use the 'IP Group' table.
These host names are simply replaced with the names
configured for the Source and Destination IP Groups
respectively.
 For a detailed description of the table's individual
parameters and for configuring the table using the Web
interface, see ''Configuring IP-to-IP Outbound
Manipulations'' on page 212.
 For a description on configuring ini file table parameters,
see ''Configuring ini File Table Parameters'' on page 368.