Dell PowerConnect 5324 Command Line Interface Reference Manual

Clock 101
Command Mode
Interface configuration (Ethernet, Port-Channel, VLAN) mode
User Guidelines
• Use the sntp client enable Global Configuration mode command to enable broadcast clients
globally.
• Use the
sntp anycast client enable Global Configuration mode command to enable anycast
clients globally.
Examples
The following example enables the SNTP client on the interface.
sntp unicast client enable
The sntp unicast client enable Global Configuration mode command enables the device to use the
Simple Network Time Protocol (SNTP) to request and accept Network Time Protocol (NTP)
traffic from servers. To disable requesting and accepting Network Time Protocol (NTP) traffic from
servers, use the
no form of this command.
Syntax
sntp unicast client enable
no sntp unicast client enable
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
• Use the sntp server command to define SNTP servers.
Examples
The following example enables the device to use the Simple Network Time Protocol (SNTP) to
request and accept Network Time Protocol (NTP) traffic from servers.
Console (config)# sntp client enable
Console (config)# sntp unicast client enable

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2